Plasters

 

-To increase the adherence: In Gypsum based Plasters, use "Primel 600" for the gross concrete surfaces in the internal spaces.
-To minimize the scratches: Use nets on the concrete-wall connections.
-To provide homogeneity: In Cement based plasters, don’t make extra trifle on the final surface. After trifle, apply sponge trifle procedure.
-In the plasters applied manually, strictly comply with the water proportions.
-Homogenous mixture: In machine applied plasters, keep the water proportion constant.
-In the plasters, don’t make applications under +5 C and over + 35 C.
-To increase the adherence capability of the material: In the plasters, apply maximum 2.5 cm thickness in a single layer.
-To increase the adherence: In Gypsum based plasters, apply maximum 2.5 cm, if more is required, apply the 2nd coat before the 1st coat settles.
-To increase the adherence: In Cement based plasters, apply maximum 2.5 cm in a single layer, if more is required, apply the second coat the next day.
-Don’t add additives such as sand, cement, gypsum plaster etc. to the plasters.
-To prevent scratches: In Cement based plasters, don’t apply early smoothing.
-To increase the adherence: In plasters, clean and moisten the surface before application.
-To prevent scratches and increase resistance: In the plasters, apply curing after plaster in compliance with the seasonal conditions.
-To provide homogeneity: “Mix Eltek SD” with an electrical hand mixer.
-To prevent scratches early water loss: On facades exposed to excess wind, protect the plaster against rapid drying.
-In cement based plasters, apply paint application 28 days after, according to the seasonal conditions.
-In gypsum plaster based plasters, apply paint application 10 days after, according to the seasonal conditions.
-In cement based plasters, place maximum 8 bags on top of each other in order to prevent squeezing.
-The net life of Cement based plaster in a non-humid environment is 6 months. Don’t forget that the material would petrify otherwise.
-On the facades that face north, and receive excess rain, use water resistant plaster.
To increase the adherence: On gross concrete surfaces, mix “Primel Powder” and “Primel 200” at appropriate proportions (1/3) and use this before the Cement based plaster applications on the internal and external facades.
-On Gas-Concrete surfaces make direct application in gypsum plaster-based plasters without using “Primel”.
-On Gas-Concrete surfaces, apply powder “Primel” before applying cement-based plasters. -Start application by curing after 72 hours.
-In order to prevent color tone changes: In “Colormatik” applications, keep the application thickness and machine water level constant.
-In Gypsum based plasters, pre-application of “Alçımatik” should be min 8 mm; and “Satenmatik” application should be min 3 mm max 8 mm.
-To prevent squeezing: In Gypsum based plasters place maximum 8 bags on top of each other.
-In Gypsum based plasters, don’t forget that the shelf life is max 3 months.
-In Gypsum based plasters, don’t forget to clean the reinforcing bars in the columns, beams and the ceiling with anti-rust paint.
-Use “Sapser Rapid” in rapid ground applications.

© ENTEGRE Tüm Hakları Saklıdır.