SILICONE EXTERIOR PAINT FINISH
TECHNICAL DATA SHEET
 
 
EXTERIOR PAINT FINISH WITH SILICON INTEGRATED
Acrylic Emulsion Based Silicon Doped with high coverage Own Water Based Exterior Paint Value
 
APPLICATION
Conventional plaster, concrete, gas concrete, concrete , particle board, fiber cement , brick, putty and painted exterior surfaces, decorative and protective surface coating used.
 
PROPERTIES
Acrylic binder and containing silicone additives
Highly breathable ( water vapor permeability ) have
Low water absorption
Atmospheric conditions , solar radiation, friction and wear-resistant, protects the surfaces
Dirt -repellent properties providing protection and aesthetic appearance
Applications with ease
With high closing force
With good adhesion to the surface applied to
It has a high lifetime .
 
APPLICATIONS
SURFACE PREPARATION
Application surface , mold oil, dust, paint and adherence reducing material must be purified .
Repair cracks and holes prior to application of the same material or a suitable repair mortar should be done with Integrated .
The newly builtconventional plastered surfaces . 21 days (20 ⁰ C) for drying plaster should be expected.
 
PRODUCT PREPARATION AND APPLICATION
Newly plastered surfaces before painting INTEGRATED SILICON -BASED EXTERIOR ACRYLIC PRIMER must be applied .
Prepared surfaces EXTERIOR PAINT FINISH WITH SILICON INTEGRATED 10-20% by volume thinned with water and applied by brush or roller in 2 layers and layers of ambient temperature , humidity, depending on a minimum of 6 hours.
 
CONSUMPTION
1lt in a single layer . 10-12 m²
 
TECHNICAL SPECIFICATIONS

view

Matt and color

The chemical structure

Acrylic emulsion doped silicon

Density

1,60 ± 0,02 g/m³

Drying time ( 20 C de %50 RH )

Min 24 saat

Recoat time

Min 6 saat (20°C, % 50 RH)

Thinner

Su

Thinning rate

%10-20

Recommended practice times

2 layer (the lower surface may vary depending on the condition)

 

 
PACKAGING AND STORAGE
 
· 15 lt. 'Health are shipped in plastic packaging.
 
· Dry and frost-free environment must be stored in unopened original packaging.
 
 
 
WARNINGS
 
· Before use in paint cans should be mixed until homogenous.
 
· Application of +5 ° C to +35 ° C temperature is recommended.
 
· The application field and to opt out instructions.
 
· Application Clean your tools with water immediately after use.
 
· For more information, please request product safety data sheet.
 
· All other applications and for technical questions about the conditions please consult us.
 
 
 
CERTIFICATE OF CONFORMITY
 
TS 7847 conforms to.

The above data have been obtained in laboratory. For more information, please consult our Technical Department.
 
Integrated reserves the right to change the above information.
 
Not responsible for any errors that may result from incorrect practices are integrated.

 

© ENTEGRE Tüm Hakları Saklıdır.