PRODUCTS

SURFACEFiX KUVARS®Surface Hardener With Quartz

3 Different Colour Options

APPLICATION FIELD

Applied on fresh concrete without joints in order to increase wear resistance and prevent surface dusting in garages, parking lots, service stations, warehouses, surfaces exposed to heavy traffic, mechanical workshops, loading-unloading areas, and all building floors.

REQUIREMENTS

  • Has a high wear resistance and surface hardness thanks to the quartz aggregates it contains.
  • Provides a smooth, hard surface on recently cast concrete and screed.
  • Does not require much labour thanks to its easy application.
  • Prevents cracks on the surfaces.
  • Facilitates cleaning on the surfaces it is applied.
  • Allows achieving of surfaces resistant to wear and with high resistance.
  • Provides superior performance in areas where surface pressure is high thanks to its high hardness level.

TECHNICAL VALUES

Dry Bulk Density, kg/m³

1500 ± 200

Wet Bulk Density, kg/m³

2000 ± 200

Compressive Strength, N/mm²

≥ 45

Bending Strength, N/mm²

≥ 7

Wear Resistance, cm³/50cm² (Böhme method)

≤ 15

 

APPLICATION

SURFACE PREPARATION  

  • PRİMEL 200® shall be applied to adapt old and new concrete before casting of the fresh concrete. 
  • There shall not be much water on the surface.
  • Move collected water away from the surface.

PREPARATION of the MORTAR  

  • The application process shall be started when the concrete cast in advance has the consistency where a footprint shall be left on the concrete.
  • First, spread 2/3 of the material on the surface. 
  • When you finish the spreading operation, wait until the spread material absorbs the water in the concrete and dampens. 
  • Then, it shall be ensured to integrate with concrete by applying low speed mechanical trowel.
  • The remaining part of the material shall spread on the floor, it shall be ensured that it is absorbed by the surface and then it shall be finished.
  • The finishing operation shall be performed by a high speed mechanical trowel when the surface reaches the hardness to be walked on.
  • After application, PRIMEL 500® curing material shall be used to prevent contraction cracks and improve the performance of the surface hardener.

CONSUMPTION

Consumption: 5 - 8 kg/m² as per the intended use.
Consumption: PRIMEL 500® ; 200-250 g/m²

PACKAGING

25 kg polyethylene-reinforced kraft paper bags,

(delivered in pallets or as sling-bags upon request.)

STORING

1 Year Shelf Life*

* If stored in its original package without opening the package under dry, frost free conditions

 

(1 week after opening the package.)

CERTIFICATE OF CONFORMITY

TS EN 13813 /December 2004 /CT-C35-F7

RECOMMENDATION

  • When applying the surface hardener, the powdered material shall not be thrown away over long distances so that the aggregates are not separated (to prevent segregation).
  • Depending on the ambient temperature, the construction joints shall be cut 1-4 days after the application.
  • We recommend that the application shall be performed between +5°C and +35°C.
  • Do not apply under direct sunlight.
  • Do not go beyond the application field and the rules.
  • Do not inhale it directly. Wash your eyes with plenty of water in case of contact with eyes, seek medical attention if required.
  • For detailed information, please request the security data sheet.
  • Contact us for your technical questions and for your questions about all other application conditions.