APPLICATION
Surface Preparation
The substrate must be sound and free from oil, grease, rust, paraffin, paint, bitumen residues and any other materials that may prevent adhesion. Remove all loose particles. To improve adhesion, prime the substrate with SUTOP® EBT-1N diluted with water at a ratio of 1:5. Allow the primer to dry before applying the product.
Application Conditions
-
Do not apply to frozen surfaces.
-
The substrate must be dry and free from dust and materials that prevent adhesion.
-
Take the necessary precautions in areas where water or water vapour is present on the negative side.
-
Before application, check substrate moisture and adhesion, and determine the dew point.
-
This product must be applied only by experienced professionals.
-
Refer to the safety data sheet for further information.
Application Details
Mix the product with a mixer operating at 400–600 rpm until a homogeneous mixture is obtained (approximately 5 minutes). Use the mixture without prolonged delay and consume it within 1–2 hours. Apply the prepared material to the primed substrate.
CONSUMPTION
Consumption for a minimum of 2 coats is 1.5–2 kg/m². (May vary depending on substrate characteristics and application conditions.)