APPLICATION
SURFACE PREPARATION
The surface must be thoroughly cleaned of formwork oil, dust, paint and substances that reduce adhesion. Before application, cracks and holes must be repaired using suitable Entegre Repair Mortars. If necessary, the application surface should be dampened with water.
On smooth fair-faced surfaces and concrete ceilings and walls, PRİMEL 600® is used as an adhesion enhancing primer before application.
Application is started after the surface has dried.
MORTAR PREPARATION AND APPLICATION
First, water is poured into the mixing container, then ALÇIPER® is added (16.5-17 L water/30 kg bag) and mixed until all lumps are eliminated. Allow to stand for 5 minutes, then mix again to obtain a homogeneous mixture. The application thickness should be between 8 mm and 2.5 cm in a single coat. If the thickness exceeds 2.5 cm, a second coat with a maximum thickness of 2.5 cm is applied before the first coat sets.
The prepared mortar is applied with a plastering shovel or trowel.
The surface is then levelled with a screed.
ALÇIPER® and SATENPER® are mixed and applied to the surface.
To give the surface its final finish and prepare it for painting, after the surface has hardened, it is smoothed with a final coat of SATENPER®.
CONSUMPTION
Approx. 10,0 kg/m² for 1 cm plaster thickness.